What Does Monogram Dishwasher Error Code i10 Mean?

Error code i10 on a Monogram dishwasher indicates the appliance is not filling with enough water. The control system expected the water level to reach a set point within a certain time, but the tub is filling too slowly or not at all.

Common Causes

  • Partially closed water supply valve – The hot water shutoff valve under the sink is not fully open.
  • Faulty water inlet valve – The solenoid valve is failing to open fully.
  • Low household water pressure – Pressure below 20 PSI results in slow fills and an i10 error.
  • Plugged inlet valve filter screen – Mineral scale has blocked the screen at the valve inlet.

How to Troubleshoot

  1. Fully open the supply valve – Turn counterclockwise until it stops.
  2. Clean the inlet screen – Disconnect the water supply hose and clean the filter screen at the valve connection.
  3. Check pressure at the tap – Run the hot water at the kitchen sink; a weak stream indicates low household pressure.
  4. Reset – Power cycle the dishwasher and run a new cycle.

When to Call a Professional

If i10 persists, the water inlet valve needs replacement. Call 844-752-7887 for fast Monogram service.

Need Help? If the error code hasn't resolved after basic troubleshooting, call our certified Monogram technicians at 844-752-7887 for professional diagnosis and same-day repair.